Comments
-
Yes but still the same, device not registered :-( I tried a reboot after it was updated to 7.1.1-7051-R5653, but it still says Device Registration needed for some reason :-/ If I look into /Device/Settings/Licenses it seems to be registered as it shows the info correct. I did an extra check to verify if this "Periodic…
-
Anyone else with the same error? " Minor Device Registration needed " ? after upgrade to SonicOS 7.1.1-7051-R5653. And yes the firewall is registered and synchronized.
-
I have experienced it on my own TZ 370, as well as on a couple of our customers' TZ 270 the only "solution" was as you mentioned yourself to restart the firewall, I will waiting for new firmware to be released. I do have a backup of their config, before upgrade but some of them are on remote site which i cant access.…
-
Hi @MustafaA I did took a look on the packet capture, and did a control of the setup for the switch. All settings seems to fine for tagging VLAN, but ingress filtering was set to disabled (default setting for the switch) I have enabled ingress filtering and have not for the last hours had a IP Spoof alert.
-
Yes you're right, thinking Sonicwall is aware of all these bugs. I must honestly admit I am not further impressed by the new Sonicwall, preserved the new graphic design is nice, but what does it help when the stability lags or is completely lacking. My own TZ370 has been running for almost 70 days, without any error until…
-
Yes, I am just waiting their response and hopefully they have a fix.
-
I was able to get Netextender to work as expected, after a factory reset. Netextender is running fine on my Windows 10 Pro laptop, and my work iPhone 11. But on my own Samsung Galaxy S10+, it is not working at all due to Compression Control Protocol (CCP). In my case I am able to connect with Mobile Connect and browse LAN…
-
Hi all Thank for all of your suggestions, if I swap my TZ 370 with my old TZ 500 it just running fine with Netextender which have a lot more complex setup than my TZ 370, on the same internet connection. I will try to do a factory reset, and see what happens.
-
Hi @Ajishlal Thanks for your suggetion, but it was already enabled. I think it must be a bug or something, as I have a another TZ 270 running with same firmware as my TZ 370 but where it works on TZ 270.
-
Hi Shipra Have testet with multiple users and locations also, WAN ip is static. Even if try to open the lan ip of firewall http://192.168.2.1:4433/ site can't be shown
-
Just a short update on my troubleshooting, I took a backup of my current settings from TZ370 which ran FW 7.0.1-R1262 Downgraded to R906 and then imported my settings, and boom the IPSEC VPN worked! The conclusion must be to downgrade firmware if you want to use VPN 🧐
-
Have unfortunately not had time yet, but will soon do it.
-
Yeah it is frustrating indeed🙄 /Martin
-
Yes these settings below are from my TZ500 which are working just fine with USG firwall. Same settings on TZ370 (not working) Settings on Unifi USG firewall, works fine with TZ 500 Have searched a lot as well as read in the forum, it is a bit disappointing that simple things do not work properly. Also discovered another…